GlowRight Outdoor Guardian Light 3.0 Max
Installations, Tips and FAQs
What's in the box
Step by Step Installations
*Install the light at where the solar panel gets direct sunlight without any shelter.
*Install the light ideally within 26ft (8m) above the floor for better motion detection performance.
*The light must be turned on in order to charge under the sun. Please make sure it is switched on after installation.
Remove the sticker on the back of the hook and apply the glue, fill in any uneven surface on the wall if necessary to make sure it’s flat for sticking.
Leave dry for 12 hours with the temporary sticker to fix the position.
Hang on the light. Turn it on, switch to your desired mode, and begin to charge in the sun.
Insert the cable ties through the mounting holes.
Tie the light to a pole, trunk or fence.
Measure and mark hole spacing. Drill holes in the wall. Insert raw plugs and push in firmly.
Install the light by inserting the Screws. You may rotate the solar panels and light to make space for the installation.
Remove the sticker on the back of the hook and apply the glue, fill in any uneven surface on the wall if necessary to make sure it’s flat for sticking.
Leave dry for 12 hours with the temporary sticker to fix the position.
Hang on the light. Turn it on, switch to your desired mode, and begin to charge in the sun.
Insert the cable ties through the mounting holes.
Tie the light to a pole, trunk or fence.
Measure and mark hole spacing. Drill holes in the wall. Insert raw plugs and push in firmly.
Install the light by inserting the Screws. You may rotate the solar panels and light to make space for the installation.
How to use it?
1. Press the Power button to switch on the light.
2. Press the Mode button to choose lighting modes.
|
1
|
Motion Mode
Low Light → Bright Light |
|
2
|
Motion Energy Mode
Dark → Bright Light |
|
3
|
Stay-On Mode
Stay on a Low Light throughout the night. |
Frequently Asked Questions
A full charge takes around 5 hours under direct sunlight. It should charge up fully during daytime.
It could last for months of use depending on how often you activate the light.
With an average of 8 activations a night, a full solar panel charge can last up to 20 days on Motion Mode, 25 days on Motion Energy Mode, and 36 hours on Stay On Mode.
You can set the light on continuous lighting or only activates with motion.
- Motion Mode: A Low Light lights up at dusk. Replaced by a Bright Light when motion is detected.
- Motion Energy Mode: Only activates a Bright Light when motion is detected.
- Stay-On Mode: Stay on a Low Light throughout the night.
With a shade covering up the solar panel, the light will not receive as much sunlight.
For best performance, we recommend you to install the light at a place with no shades or cover in order to get the most out of the sunlight.